|
The Heat Siphon will perform well in any outdoor location with three (3) things present -
1. Fresh Air - 2. Electricity - 3. Pool filter system piping.
Heat Siphon may be installed virtually anywhere outdoors. For Indoor Pools Consult the Factory. Unlike a gas heater it has no draft or pilot light problem in a windy area. Direct sunlight is not a concern since Heat Siphon's cabinet is made of a UV stabilized, flame retardant plastic.
![]() DO NOT place Heat Siphon in an enclosed area with a limited air volume where Heat Siphon's discharge air will be recirculated. or close to shrubs which can block air inlet These locations rob the Heat Siphon of a continuous source of fresh air which reduces it efficiency and may prevent adequate heat delivery.
1. Allow 24 to 36 inches of open area all around the Heat Siphon for good air circulation and service access.
2. Heat Siphon should be level to help drainage of condensation and rainwater.
3. To minimize noise position the flat side of the unit toward sitting area.
How Close To Your Pool?
Normally, the pool pump and Heat Siphon are installed close together and within 25 feet of the pool. The longer the distance from the pool, the more heat loss from the piping. Since most of the time the piping is buried, the heat loss is minimal for runs of up to 50 feet (50 feet to and from the pump = 100 feet total) unless the ground is wet or the water table is high. A very rough estimate of heat loss per 100 foot is 2500 BTU/hr for every 10° F difference in temperature between the pool water and ground surrounding the pipe, which translates to about 3% to 5% increase in run time.
| 
